USER INSTRUCTIONS 1 To protect your health and to prevent serious injury or death, it is important to read all follow the instruction provided with the enclosed product. Please read all warning printed on the packaging box.
2 The mask needed to be inspected prior to each use to assure there are no holes in the breathing zone.
LIMITATION Do not use the respirator or enter or stay in a contaminated area under the following circumstances:
a Atmosphere contains less than 19.5% oxygen.
b If you smell or taste contaminant.
c For protection against gases or vapors.
d Contaminants or their concentrations are unknown or immediately dangerous to life or health.
e For sandblasting, paint-spray operations and asbestos treatment.
f In explosive atmospheres.
WARNING 1 This mask marked “NR”, shall not be used for more than one shift.
2 Never substitute, modify, add, or omit parts in the configuration as specified by the manufacture.
3 This mask helps protect against certain particulate contaminants but does not completely eliminate exposure to the risk of contracting disease or infection.
4 Do not use the particle half mask with facial hair or any other conditions that may prevent a good face-seal, the requirements of leakage will not be achieved.
5 Discard and replace the mask if:
a The mask is removed whilst in the contaminated areas.
b Clogging of the mask causes breathing difficulties.
c The mask becomes damaged.
1 Place under chin and press the mask freely against your face with the nose clip on the bridge of your nose, see picture 1 and 2.
2 Pull the head harness behind to ears, attach the head harness to the retaining clip, improve comfort and prevent leakage, see picture 3 and 4.
Note: The head harness on the same side should cross above and below the ear respectively.
3 Using both hands, mold the metal nose clip to the shape of nose, see picture 5.
4 To check for proper fit, cup both hands over the mask and exhale vigorously. If air leaks around the nose, tighten the nose clip, if air leaks around the edge, reposition the head harness for better fit. Double check the seal and repeat the procedure until the mask is sealed properly, see picture 6.
Note: Entry into a contaminated area with an improper fitting mask may result in illness or death.
STORAGE The mask should not be removed from its package until it is required for use, and should be discarded after use.
Validity: 3 Years Date of Production: See packaging
Regulation (EU) 2016/425
Notified Body: CCQS Certification Services Limited
Address: Block 1 Blanchardstown Corporate Park, Ballycoolin Road, Blanchardstown, Dublin15, D15 AKK1, Ireland (NB 2834)
Carte Medical Equipment (Suzhou) Co., Ltd.
Address: No.1978, Fenhu national Road, Wujiang City, Suzhou City, Jiangsu Province, China
Service Hotline: +86-400-112-1978
Made in China